The 8 Types of Trenching and Excavation Hazards

What is a Trench?

A trench is an excavation (or hole in the ground) where the depth is greater than the width.

One tried and tested method is to ensure workers receive adequate training on OSHA regulations and safe work practices in accordance with Federal OSHA Regulations 29 CFR 1926 Subpart P which provides guidance on specific excavation requirements and the use of protective systems for excavation and trenches.

Did You Know?

There are three types of protective systems – Sloping, Shoring, and Shielding.

      To Learn More Enroll In Our
      OSHA Competent Person for Excavation, Trenching, and Shoring Training Course

Our OSHA Competent Person for Excavation, Trenching, and Shoring Training course has been developed by OSHA-authorized trainers and provides detailed guidance on soil classification, protective systems, and safe work practices.

Trenching and Excavation Hazards

Let’s discuss the eight commonly encountered trenching and excavation hazards that cause worker injury and death in the construction industry.

1. Trench Collapses or Cave-Ins

A trench collapse or a cave-in occurs when the walls of the trench or excavation site collapse inwards due to instability or improper use of safety techniques such as sloping or benching the sides of the trench, shoring or supporting the sides of the excavation, or placing a shield between the sides of the excavation/trench and the work area.

Some of the most common reasons for trench or excavation collapses are attributed to unstable soil, vibrations due to machinery being used nearby, vibrations from heavy traffic passing close to the trench, flooding, heavy rainfall, and excessive pressure placed on the edge of a trench.

Trench or excavation collapses result in workers being buried under tons of sand and rock, suffocating due to being smothered by soil, or suffering other lesser fatal injuries which can still put them in hospital and require injury leave.

It is, therefore, a competent person’s responsibility to inspect worksites daily before the start of each shift, and as needed thereafter (for example, a sudden heavy rainfall occurring after the pre-work inspection has taken place that could result in excess water gathered in the trench affecting soil stability).

2. Falling Hazard

Workers working in trenches and excavations are exposed to the hazard of falling into the trench or excavation. This is more common when workers must cross over excavations to get to the other side. Putting-up safety signs, installing guardrails for walkways that are 6 feet or higher from the bottom of the trench or the lower level, and/or placing barriers around the edges of trenches and excavation sites can reduce the risk of workers falling inside the trenches and sustaining injuries.

3. Struck-By Hazard

This happens when objects, tools, or other equipment falls on workers working inside the trench or excavation. This could be due to the tools being placed too close to the edge of the trench resulting in them slipping and falling inside the trench causing injury to workers.

By placing barriers at the edge of the trench and excavation areas, workers’ risk from struck-by hazards can be greatly reduced as this would stop tools and equipment from accidentally falling inside trenches.

4. Superimposed Load or Surcharge Hazard

When excess loads or weight are placed at the top of a trench, there is a risk of such vertical loads (e.g., excavated soils and other materials, vehicles, or equipment) resulting in reducing the stability of a trench or excavation area. This excessive pressure on the soil could cause the trench edge to collapse resulting in the machine or the excavated soil falling inside the trench and risking serious injury to workers. Therefore, when the stability of the trench is reduced it can cause the dual hazards of cave-ins and falling loads.

Thus, following OSHA’s requirement to maintain a distance of two feet from the edge of the trench or excavation before placing any load will minimize the hazards faced by workers when working inside trenches. In addition, a barrier can also be placed for extra protection.

5. Atmospheric Hazards

Trenches and excavation sites are prone to atmospheric hazards due to the worksite being underground. Workers can be exposed to toxic atmospheres (due to the presence of toxic gases or chemicals), or suffer from asphyxiation caused by a shortage of, or lack of, oxygen due to a cave-in or the nature of the confined space (meaning the trench or excavation site) they are working in.

According to OSHA’s Excavations Standard, 29 CFR 1926 Subpart P, a competent person must undertake daily inspections to test trenches and excavations for hazardous atmospheres. These inspections should be done before work begins and as necessary throughout the shift. Furthermore, employers must also provide workers with adequate respiratory protection or ventilation in trenches or excavations that contain less than 19.5 percent oxygen (an oxygen-deficient atmosphere) and where a hazardous atmosphere is detected.

6. Hazards Caused by Mobile Equipment and Machinery

When workers operate mobile equipment or machinery close to trenches and excavations, the judgment of when to stop before reaching the edge of the trench or excavation can sometimes be incorrect. Therefore, using stop logs and barricades can help reduce the hazard of equipment being too close to the edge. Using a communication system such as hand signals between equipment operators and the ground workers is also a good safe workplace practice that can be adopted at excavation sites.

7. Electrical Hazards

Often working underground results in workers being exposed to underground electrical wiring, underground power lines, or other underground utilities such as telephone lines and water. This is a cause of concern as workers could be exposed to electrical hazards such as shocks and electrocutions as well as fires and explosions. To safeguard workers, employers should contact the utility companies and the location of the underground utility and put in barriers to avoid the area when working in the trench or get the water supply or power shut down before work begins in trenches.

8. Drowning and Flooding Hazards

Working in trenches and excavations exposes workers to the hazards of drowning and flooding. Flooding can occur due to ruptured water pipes in the excavated area or even from heavy rainfall or thunderstorms. Employers should ensure the utility underground location is identified in advance, and barriers placed around it with relevant safety signage when work is being carried out. Furthermore, precautions such as harnesses and lifelines, shielding systems, and other water removal measures can be utilized to reduce water accumulation in excavation sites. These must be supervised by a competent person. In instances of rainstorms, the excavation site should be cleared of workers and a competent person must inspect the site before work begins again to ensure that the trench is safe from the danger of cave-ins or re-flooding.

OSHA-Complaint Safety Training

To protect workers from trenching and excavation hazards, employers must train workers to recognize trenching hazards, understand the dangers to safety and health of exposure to such hazards, and ways to minimize such hazards. As competent persons play a critical role in ensuring worker protection when working in trenches and excavation sites, employers must train workers to be competent persons when working in excavations and trenches. Our OSHA Competent Person For Excavation, Trenching, and Shoring Training course will provide detailed guidance and protect workers and reduce employer liabilities and work stoppages due to accidents and injuries.

OSHA Fatality Inspection Data. (n.d.). Reports of fatalities for CY17-21. Website. https://www.osha.gov/fatalities